Blog

By on 26th July, 2013

Seaward - Voltage Detectors & Electrical Testing Portable appliance testing (PAT Testing) has become a fundamental requirement for providing electrical safety in the workplace. The Health and Safety Executive’s (HSE) Memorandum of Gui... Read More - PAT Testing Explaine...

Category:  Electrical Safety & Arc Flash


By Chris Dodds on 26th July, 2013

      Today, T&D have supplied Lucy Zodion Feeder Pillars to provide on-site low voltage LV electricity distribution at Manchester City Football Club. The feeder pillars will house electrical equipment to control a... Read More - Lucy Zodion Feeder P...

Category:  Power Distribution & Feeder Pillars


By Chris Dodds on 24th July, 2013

ABB Low Voltage Products - 2013 Price List from Thorne & Derrick (Power Products)   ABB LV Low Voltage Products * ABB Contactor Relays * ABB Capacitor Contactors * ABB Contactors * ABB Voltage Plugs * ABB Terminal Blocks * AB... Read More - ABB Low Voltage Pric...

Category:  ABB Power Products


By on 22nd July, 2013

One of the most common causes of failure of polymeric cable accessories is breakdown of the cable insulation at the end of the screen cut. This is the result of internal partial discharges brought about by one or more of the following: poor cab... Read More - Treating The Screen ...

Category:  HV Cable Jointing & Terminating


By on 15th July, 2013

Cable Accessories The SebaKMT MFM 10 cable sheath testing equipment is an easy and reliable tool to test the sheath of cables. The MFM 10 cable fault locator also performs a pre-location pinpointing of detected faults.   The SebaKMT MFM 10... Read More - SebaKMT MFM 10 Cable...

Category:  HV Cable Jointing & Terminating


By Chris Dodds on 15th July, 2013

Roxtec Cable Sealing Systems. Roxtec Cable Transits   Sealing cables into substations must satisfy several substation design criterion: structural and environmental integrity, grounding, fire, protection, waterproof cable sealing and ease ... Read More - Sealing Cables In Su...

Category:  Cable Transits & Duct Sealing


By Chris Dodds on 15th July, 2013

    Roxtec seals protect Wind Farms against water, gas, fire, electro-magnetic distriburbance, dust, vibration and rodents - correct technical specification of Roxtec Seals can avoid warranty claims and maximise uptime. Flexibl... Read More - Cable Entry Sealing ...

Category:  Cable Transits & Duct Sealing


By on 15th July, 2013

Electrical Safety The SebaKMT ESG NT earth fault locator is used for the high accuracy pinpointing of a sheath fault. The SebaKMT ESG NT has state of the art technology in connection with a bright, sun readable TFT colour display which a... Read More - SebaKMT ESG NT Digit...

Category:  Electrical Safety & Arc Flash


By Chris Dodds on 12th July, 2013

Cembre Cable Lugs - Contained Narrow Palm Cable Terminals. Palm widths of standard copper lugs are often too wide to fit 150A to 250A circuit breakers, therefore preventing low voltage cable termination into the terminal blocks. Cembre A-M rang... Read More - Cembre Contained Pal...

Category:  LV Cable Jointing & Terminating


By Chris Dodds on 12th July, 2013

Cable lugs are often over-looked in the specification and performance of HV high voltage electrical distribution systems, however under-specified or incorrectly specified cable lugs are major contributors to switchgear failures. Although arguably ... Read More - Cable Lugs, Crucial ...

Category:  HV Cable Jointing & Terminating


By Chris Dodds on 12th July, 2013

T&D produce customised Overhead Line Portable Earthing Kits specifically designed to meet the requirements of National Grid and utility contractors working to the requirements of EA Technical Specification ESI 43-81. Overhead Line Portable Ear... Read More - Overhead Distributio...

Category:  Electrical Equipment HV


By Chris Dodds on 11th July, 2013

33kV Heat Shrink Cable Joints. T&D have specified and supplied over 50 heat shrink cable joints to joint 33kV single core power cables - cable joints are being installed outdoor on cable tray. SPS Single Core 33kV Heat Shrink Cable Joi... Read More - 33kV Single Core Hea...

Category:  HV Cable Jointing & Terminating


By Chris Dodds on 9th July, 2013

MCT Cable Transits - Seal Cables Against Fire, Gas, Smoke & Water. T&D working with SSE Contracting have supplied 9 MCT Brattberg Cable Transit Frames to provide fire protection to LV-HV cables entering and leaving switchrooms and transfor... Read More - MCT Brattberg Cable ...

Category:  Cable Transits & Duct Sealing


By Chris Dodds on 4th July, 2013

Klauke Cable Lugs -  DIN 46235 Standard Cable Lugs DIN standard 46235 defines the application, dimensions and marking of crimp cable lugs. DIN 46235 standard allows use of cable lugs for compression of solid, stranded, fine stranded and ... Read More - Klauke Compression C...

Category:  LV Cable Jointing & Terminating


By Chris Dodds on 1st July, 2013

High Voltage Cable Terminations. Utilising heat shrink technology to provide anti-track and stress control functions, T&D can provide high voltage cable terminations for SIWO-KUL 15kV cable - this type of high voltage cable is us... Read More - Cable Terminations F...

Category:  HV Cable Jointing & Terminating


< < Newest   |   < Newer   |   Page 68 of 110   |   Older >   |   Oldest > >