3M Scotch 130C Tape

3M Scotch Electrical Tapes

3M Scotch 130C Linerless Rubber Splicing Tape 

 

3M Scotch Rubber Electrical Tapes -  3M Scotch 130C Rubber Splicing Tape 

3M Scotch 130C Electrical Tape is a highly conformable, 0.762mm thick, linerless self amalgamating EPR (Ethylene Propylene Rubber) based tape, high voltage insulating tape formulated to provide excellent thermal dissipation of splice heat.

3M Scotch 130C self bonding tape is designed for use in cable splicing and cable terminating LV-HV wires and cables. 

3M Scotch 130C Silicone Rubber Tape Features

• Linerless, self-bonding primary insulating tape rated up to 69 kV
• 3M Scotch 130C tape has high thermal conductivity
• Ethylene propylene (EPR) base
• Flame retardant cable splicing tape
• Excellent physical and electrical properties
• 3M Scotch 130C electrical tape is designed to insulate cable splices and terminate cables
• Physical and electrical properties unaffected by degree of stretch
• Unaffected by solvents normally used when splicing high voltage cables
• Compatible with common solid dielectric cable insulation
• Uniform tape unwinds from roll
• Stable over wide applications temperature range

3M Scotch 130C Linerless Rubber Splicing Tape Applications

• Primary insulation for splicing all types of high voltage cables to 69 kV
• Primary insulation for building stress cones on all HV cables up to 35 kV
• Jacketing (secondary insulation) on high voltage splices and terminations
• Moisture sealing electrical connections
• Bus bar insulations
• End sealing high voltage cables
• Motor leads
• Cable jacket repairs

3M Scotch 130C  Silicone Rubber Tape Installation

3M Scotch 130C Electrical Tape should be applied in successive half-lapped, level-wound layers until desired electrical insulation build-up is reached.

3M Scotch 130C  tape should be applied like any rubber tape : that is, the side of the tape wrapped inside the roll should be applied outside on the cable splice.

This will help prevent the roll from getting progressively further away from the work area. To eliminate voids in critical areas, highly elongate Scotch 130C tape.

Stretch Scotch 130C tape in these critical areas just short of the breaking point; doing so will not alter its physical or electrical properties.

In less critical areas, less elongation may be used. Normally, 3M Scotch 130C Tape is stretched ¾ of its original width in these critical areas. Always attempt to half-lap to produce a uniform build-up. 

When using Scotch 130C self amalgamating tape for splicing high voltage cables above 15 kV, always highly elongate the tape throughout the entire low or high voltage cable splice.

T&D UK stock 3M Scotch 130C tape.

3M Motor Lead Pigtail Splice Using 3M Scotch 130C Linerless Rubber Splicing Tape - Video Training

3M Scotch Electrical Tapes and Mastics for electrical insulation, cable jointing, corrosion protection, environmental sealing and general purpose low and high voltage electrical taping applications:

Scotch PVC insulation tapes, Scotch self amalgamating tapes, Scotch mastic sealing tapes, Scotch phase marking tapes, Scotch corrosion protection tapes, Scotch glass cloth tapes and Scotch cable jointing tapes for LV, 3.3kV, 6.6kV, 11kV and 33kV.

3M Scotch 130C Tape

3M Scotch Electrical Tapes Catalogue

3M Scotch Electrical Tapes Selection Guide