11kV HV Heat Shrink Cable Termination Kit, 3c XLPE & EPR 300-400sqmm - Prysmian HIT3XD11

Prysmian Cable Termination - 11kV Heat Shrink Kits

11kV HV High Voltage Heat Shrink Cable Termination Kits Suit XLPE & EPR Insulated Cables (BS6622 & BS6883) 3 Core 300sqmm, 400sqmm.
 
Heat Shrink Terminations, 11kV XLPE & EPR - Tested to BS7888.
 
Prysmian HV Heat Shrink Cable Termination Kit, XLPE & EPR - HIT3XD11.
 
Also : Copper Tape Screen Earth Kits, Insulating Bushing Boots Kits (Straight or Right Angled), Top Hat HV Bolt-On Cable Glands, HV Water-Blocked Crimp Lugs (Prysmian or Cembre).

Heat Shrink Cable Terminations - Preparation
Before shrinking one tube onto another or onto polymeric cable insulation or before applying any mastic, clean and degrease the underlying surfaces. Where any of these surfaces are semi-conducting or stress controlling take care not to drag any carbon particles onto any high voltage insulating components. Metal cable sheaths/wire armours of cables should always be scraped / abraded and degreased before applying any earth bonds or mastics. Always use the correct cable jointing tools to strip insulation, cable sheath and remove semi-conducting screens - HV Cable Jointing Tools

When using heatshrink cable terminations.......
• Use a propane (preferred) or butane gas torch
• Use heat shrink torch in a well-ventilated area
• Obtain soft blue flame with yellow tip. Pencil blue flames should not be used
• Aim heat shrink torch in direction of heatshrink to preheat material
• Continuously move flame to avoid scorching termination
• Any cut tubing should be smooth with no jagged edges
• Recovered tubing should be smooth and wrinkle free


Note - Remember to fit any cable gland or non-splitable gland plates over the cable before starting the heat shrink termination. If possible lower the cable gland plate to ease termination kit installation. The cable terminations have been designed for use in a cable box with a minimum of 400mm from the centre line of the bushing to the base of the high voltage cable box.
 

11kV termination kits suitable for terminating high voltage power cables into air insulated HV cable boxes comprising of anti-track (red) and stress control (black) heat shrink sleeves, cable breakout, mastics and sealants - 11kV termination kits available for three core polymeric (EPR & XLPE) and paper (PILC) insulated cables - cable termination kits utilsing heat shrink technology suitable for outdoor, pole and overhead line applications available. Cable glands, bushing boots, solderless earth kit and HV cable lugs to enable the termination of 11kV cable also available.

Adobe 11kV HV Heat Shrink Cable Termination Kit, 3c XLPE & EPR 300-400sqmm

Adobe 11kV HV Heat Shrink Cable Termination Kit, 3c XLPE & EPR 300-400sqmm, Jointing Instruction

UK Time - GMT:

11kV HV Heat Shrink Cable Termination Kit, 3c XLPE & EPR 300-400sqmm - Prysmian HIT3XD11