Elastimold Connectors 600 Series Interface D Cable Connectors HV

Elastimold Connectors 600 Series Interface D Cable Connectors HV

Elastimold Connectors

Elastimold Cable Connectors

 

 

 

600 Series Interface D Compact Elastimold Cable Connectors and Bushings connect and terminate HV cables to Interface D bushings on switchgear and transformers.

Elastimold provide high voltage cable accessories to suit the 7 main bushing interfaces : A, B, C (Compact), C (Symmetrical), D, E and F.

Elastimold cable joints, cable terminations, epoxy bushings, angled (elbow) and straight plug-in or bolted separable connectors for connecting, jointing and terminating high voltage cables.

 

600 Series Interface D, Elastimold Bushings  

  • Bushing Voltage Range 12kV-24kV
  • Bushing Current Rating 800Amps
  • Bushing Type 5/8" Bolted Aluminium Stud

Elastimold separable elbow connectors are high voltage cable terminations used to connect polymeric (XLPE or EPR insulated) power cables to HV equipment including transformers, switchgear, capacitors and motors.

 

600 Series Connectors - 676LRA Tee Connectors, 12-24kV 1250Amps 35-630sqmm

Slip on cable connectors - quick to install to high voltage switchgear and transformers (oil, air and gas insulated)

Touchproof cable terminations -  made from conductive EPDM rubber, fully screened HV termination for safety

One part cable termination - built-in stress relief, insulation and outer semi-conductive layers

Maintenance friendly - readily disconnectable cable connector for high voltage maintenance work

Compact cable connectors - space-saving HV cable terminations for SF6 gas insulated switchgear (GIS)

EPDM rubber cable connectors - resistant to ozone, corona, chemicals, water and atmospheric pollutants

Flexibility - Elastimold cable connectors are disconnectable and re-useable. Re-use of the high voltage cable connector permits site re-location of HV electrical equipment without requiring cable re-termination.

HV High Voltage Cable Connectors, Specification - Elastimold dead-break separable cable connectors suit all international high voltage bushing interfaces for the termination of HV cable into switchgear, transformers and motors. Elastimold cable connectors terminate high voltage power cables (typically 11kV, 15kV, 24kV, 33kV, 36kV up to 52kV) into SF6 GIS gas insulated switchgear including Schneider, ABB, Areva and Siemens. Elastimold cable connectors meet the requirements of ANSI/IEEE 386 & 404 and CENELEC EN50180 & EN50181 for high voltage "dead-break" cable connection, i..e connectors installed and terminated onto un-energised high voltage power cable. US specification "load-break" cable connectors for high voltage energised cable termination are available.

High Voltage Cable Connectors - Elastimold cable connectors (elbow and straight types) are specified to terminate XLPE or EPR insulated high voltage power cables with copper tape or copper wire screens up to 52kV. Cable connectors are available to suit and terminate lead covered HV cables for hydro-carbon industries (oil, gas, petrochemicals) with ATEX certification for hazardous area Zones 1 and Zones 2.

Video - Elastimold Screened Separable Connectors - 600 Series 1250A 24kV

 

Adobe

600 Series Interface D Elastimold Cable Connectors HV

Adobe

Elastimold Connectors Loadbreak & Deadbreak Elbow & Bolted Tee Connectors HV MV - 600 Series

UK Time - GMT: