Cable Rollers - Straight Cable Rollers HSP125

SEB InternationalCable Rollers

SEB HSP125 Cable Roller

  Low & High Voltage Power Cables

Cable Trench & Cable Duct Cable Pulling

Heavy duty cable rollers with zinc plating for laying cables up to 125mm diameter.

The standard cable roller used by the DNO, utility and cable laying contractor for pulling in low and high voltage electric cables.

Pictured: SEB HSP125 Heavy Duty Cable Roller

SEB HSP125 Heavy Duty Cable Roller

SEB HSP125 Cable Roller

Base Size: 350mm x 230mm. Weight: 4Kgs

The SEB HSP125 is manufactured from an all Zinc plated steel havy duty frame suitable for cables up to 125mm in diameter.

The steel frame is fitted with a large waisted steel roller running on sealed ball bearings and has a maximum load capacity of 150Kgs.

T&D UK distribute the complete range of Cable Pulling and Cable Laying Equipment for low and high voltage (LV-HV) power cable installations into underground trench or cable duct.

Cable Pulling in Trench - Horizontal Cable Runs

Cable pulling contractor should ensure cable to be pulled in (LV or HV) should be supported on free running cable rollers with no projections or sharp edges to prevent snagging and subsequent cable sheath damage.

Straight cable rollers shall be placed in the cable trench to prevent the LV-HV cable from dragging on the cable trench bottom or in mud.

The cable roller spacing required to achieve this will depend on the cable type being installed and the pulling tension along the route.

A leading roller should be used to support the cable over the entire cable drum width immediately before being pulled into the trench.

Adobe Cable Laying & Pulling Equipment for Trench - SEB Catalogue

Adobe Straight Cable Rollers - Cable Roller Ref : HSP125

UK Time - GMT:

Cable Rollers - Straight Cable Rollers HSP125