|
||||
![]() |
|
|||
![]() |
||||
![]() |
![]() |
|||
![]() |
||||
![]() |
||||
Cable Rollers for Pulling In Low & High Voltage Power Cables into Cable Trench & Cable Duct
Cable rollers and cable pulling equipment for the DNO, cable laying contractor, utility and electricity supply industry – this includes straight cable rollers, corner cable rollers, triple cable rollers and specialist cable rollers for pulling underground cables into trenches and ducts up to 33kV. Cable rollers should always be used when pulling cables.
Straight cable runs are pulled in using straight cable rollers suitably placed in the cable trench to prevent the cable being dragged on the trench bottom or in mud - cable roller spacing is dependent on cable type being laid and the cable pulling tension along the route. Leading cable rollers are used to support the cable over the entire drum width immediately befor being pulled into the trench.
Cable laying applications with bends in the route require skid plates of a radius greater than the cables minimum dynamic bending radius.
T&D UK supply Cable Pulling, Cable Laying and Cable Blowing equipment for HV transmission towers and overhead lines, HV underground cables, LV distribution lines, LV-HV rail trackside and underground power, CATV, fibre optic and telecoms.
T&D UK distribute the complete range of Cable Pulling and Laying Equipment including cable rollers, cable socks, cable jacks, drum trailers, cable pulling lubricant, underground cable protection and conduit duct rod - we service the utility cable laying contractor, electrical contractor, cable jointing training schools and cable industry (distributors and manufacturers).
Cable Rollers - Narrow Trench Cable Rollers TRP76